Water Purifiers RO/UV/M/A/UF/TDS Control. (Manual, Automatic plant)
Sewage treatment is the process that removes the majority of the
contaminants from waste-water or sewage and produces both a liquid effluent suitable
for disposal to the natural environment and sludge.
Technologies in STP
ASP (Activated Sludge Process)
FBBR (Fluidized bed Bio Reactor) or MBBR (Moving Bed Bio Reactor)
SBR (Sequential Batch Reactor)
Application
Treating Toilet waste
Canteen waste
Bath waste
Dispenser ( Automatic with hot / cold / normal )
Most companies operate effluent treatment plants to reduce the potential for pollution
of receiving waters and to comply with discharge consent conditions.
Technologies in ETP
ASP (Activated Sludge Process)
FBBR (Fluidized bed Bio Reactor) or MBBR (Moving Bed Bio Reactor)
SBR (Sequential Batch Reactor)
Application
Treating all types of industrial effluents
Water Softner
Water Softner
The calcium and magnesium ions in the water are replaced with sodium irons. Since sodium does not precipitate out in pipes or react badly with soap, both of the problems of hard water are eliminated. To do the iron replacement, the water in the house runs through a bed of small plastic beads or through a chemical matrix called zeolite contain nothing but calcium and magnesium and no sodium, and at this point they stop softening the water. It is then time to regenerate the beads or zeolite.
Regeneration involves soaking the beads or zeolite in a stream of sodium ions. Salt is sodium chloride, so the water softner mixes up a very strong brine solution and flushes it through the zeolite or beads this is why you load up a water softner with salt. The strong brine displaces all of the calcium and magnesium that has built up in the zeolite or beads and replace it adain with sodium. The remaining brine plus all of the calcium and magnesium is flushed out through a drain pipe. Regeneration can create a lot of salty water.
Iron Remover
Aqua new generation iron & colour removal system is an advanced water condition is systems which removes excess inorganic iron dissolved in water through a process of oxidation. In the systems water is passed through a aeration system and filter housed in a tank. The iron in water accumulates on the filter as a precipitate their by reducing iron level to is / WHO set limited. The precipitates as to be periodically removed passing water through backwash system, we manufacture from 100 lph to 2,00,000ltrs per hour. The filtration packages are offered in MS /FRP /SS vessels as per clients requirements. The operations available are manual and automatic system
Multi Grade Filter
Multigrade filter is a depth filter that makes use of coarse and fine media mixed together in a fixed proportion. This arrangement produces a filter bed with adequate pore dimensions for retaining both large and small suspended particles. This filter performs at a substantially higher specific flow rate than conventional filters. Specific flow rates of 0.82 – 1.64 ft/min have been successfully obtained for treating waters containing 25 – 50 ppm suspended solids respectively to produce filtrate with less than 5 ppm.
Higher specific velocity
Raw water can be used for backwashing the filter